Communion Of Dreams


Get a grip. Or make one.

[For the AI’s own inscrutable reasons, Facebook considers my ballistics blog “spam”. Unable to get it resolved, I’m going to post partial info about new blog posts over there, here, so people can link it off FB. Please just ignore if shooting stuff isn’t of interest.]

A couple of weeks ago I posted about finishing a Liegi Derringer kit, then doing the laser work to customize the grips. It turned out well enough, so I decided to finish and laser a second kit, to use as a door prize for a black powder workshop I’m doing at the annual meeting of the Liberal Gun Club this fall in Las Vegas.

All went well until the time came to mount the grip to the receiver. The top mounting screw went in fine, after drilling a pilot hole. But the bottom one broke loose as I was tightening it. I took the top screw back out so I could see what the problem was. This is what I saw:

Almost looks like a tiny wooden shoe from this angle, doesn’t it?

[The entire post about this project can be found here.]

Jim Downey

Advertisement

Leave a Comment so far
Leave a comment



Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s



%d bloggers like this: